Sampling Procedures and Tables for Inspection by Attributes - Paper Format - Reaffirmed in 2018
ANSI/ASQ Z1.4-2003 (R2013): Sampling Procedures and Tables for Inspection by Attributes is an acceptance sampling system to be used with switching rules on a continuing stream of lots for Acceptance Quality Limit (AQL) specified. It provides tightened, normal, and reduced plans to. ANSI/ASQ Z1.4-2003 Sampling Procedures and Tables for Inspection by Attributes. Standard Number: ANSI/ASQ Z1.4-2003. Related Free Standards. ANSI/ASQ Z1.4-2008 sampling procedures and tables for inspection by attributes. Download ANSI/ASQ/ISO Q9001-2008 pdf $. (REFER TO AN ACCEPTABLE NON-GOVERNMENT STANDARD SUCH AS ASQC-Z1.4) (S/S BY ANSI/ASQC-Z1.4-1993) (SUPERSEDING MIL-STD-105D)BS EN ISO 11137-1:2006- Sterilization of health care products. Requirements for development, validation and routine control of a sterilization process for medical.
Abstract
ANSI/ASQ Z1.4-2008 Sampling Procedures and Tables for Inspection by Attributes is an acceptance sampling system to be used with switching rules on a continuing stream of lots for Acceptance Quality Limit (AQL) specified. It provides tightened, normal, and reduced plans to be applied for attributes inspection for percent nonconforming or nonconformities per 100 units.
Both ANSI/ASQ Z1.4 “Sampling Procedures and Tables for Inspection by Attributes” and ANSI/ASQ Z1.9 “Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming” are to be used with a continuous supply. ANSI/ASQ Z1.4 is to be used with go/no-go data (sometimes called attribute data). ANSI/ASQ Z1.9 is to be used with measurements. Also note that Z1.9 assumes a normal distribution.
ANSI/ASQ Z1.4-2008 replaces ANSI/ASQ Z1.4-2003.
Notes
Claudia's Notes:
You may be able to remember back when this document was known as ASQC Z1.4. The Standards Developing Organization that develops this standard changed it's name from the American Society for Quality Control to the American Society for Quality in 1997. When it did so, all it's document numbers changed from ASQC-xxx to ASQ-xxx!
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
MIL-STD-105 was a United Statesdefense standard that provided procedures and tables for sampling by attributes based on Walter A. Shewhart, Harry Romig, and Harold Dodge sampling inspection theories and mathematical formulas. Widely adopted outside of military procurement applications.
The last revision was MIL-STD-105E.[1]
It was officially cancelled in February 2995 by a Notice of Cancellation. This Notice was updated in March 2001 and again in February 2008. The current Notice of Cancellation (Notice 3) recommends that future acquisitions refer to:MIL-STD-1916, 'DoD Preferred Methods for Acceptance of Product',[2] or ANSI/ASQ Z1.4, 'Sampling Procedures and Tables for Inspection by Attributes'.[3]
Version[edit]
- Ver.D：Revision in 1963.
- Ver.E：Revision in 1989.
See also[edit]
- Acceptable quality limit (AQL)
References[edit]
- ^MIL-STD-105 official recordArchived 2004-10-18 at the Wayback Machine
- ^'ASSIST: A portal to military and federal specifications and standards'. web.archive.org. 6 January 2008.
- ^'The Global Voice of Quality - ASQ'. asq.org.